Graphing from the Command Log
Command results shown in the Command Log from the Stratify, Classify, Age, Benford and Crosstab commands in Analyzer can easily be redrawn as a graph.
To create graphs from command results in the Command Log, do the following:
|
1.
|
Open the Command Log by clicking the [Command Log] button on the button bar or the Command Log tab. |
|
2.
|
In the Command Log, double-click the command or anywhere in the table output below it. Analyzer immediately redraws the graph using the data in the Command Log. |
|
3.
|
You can change the graph properties or command parameters: |
|
•
|
Click [Graph Properties] on the graph button bar to change graph properties. |
|
•
|
Click [Edit Command] on the Command Log button bar to change command parameters. |